歡迎您光臨康鵬華彩新能源技術有限公司官網!

聯系我們 收藏本站

咨詢服務熱線 工業油電話:0531-58589003,13256121992
車輛油:0531-87581191,13156111992

熱門關鍵詞搜索: 潤滑油工業潤滑油 潤滑油廠家

您的當前位置:主頁 > 新聞資訊 > 公司新聞 >

如何提高導熱油的使用壽命?

來源:www.jmrksa.icu 編輯者:康鵬華彩新能源 發布日期:[2017-07-07 14:43] 瀏覽:|

  提高導熱油的使用壽命注意幾點,必須按說明的取樣化驗導熱油,發現問題,立即更換新的導熱油,突然停電,循環泵停止,流速等于0,停爐,必須養按照說明操作規程執行,一般使導熱油溫度降到100度以下方可停止S熱油泵。

  To improve the service life of heat conductive oil must pay attention to the following, according to the sampling test of thermal oil, that found the problem, replace the new oil, immediately a sudden power outage, circulating pump stop, flow rate is equal to 0, stop, must keep in accordance with the instructions for execution, generally the heat-conducting oil temperature dropped to 100 degrees to stop S heat pump.

  1、一般使用半年后,必須按說明的取樣化驗導熱油,發現問題,立即更換新的導熱油,但必須注意,不可混合不同種類的導熱油。

  1, the general use of six months later, you must follow the instructions of sampling, testing heat conduction oil, and found problems, immediately replace the new heat transfer oil, but must pay attention to, not mixing different types of heat transfer oil.

  2、防止導熱油的氧化。嚴謹導熱油>50度時與空氣接觸;這樣SS會使導熱油發生裂解,其速度快的驚人,且后果非常嚴重,要求試車人員在正常工作后,將輔助排氣管道上排氣閥關閉,切記。

  2, to prevent the oxidation of heat conduction oil. Rigorous thermal oil >50 degrees in contact with the air; this will make SS thermal oil cracking, its speed, and the consequences are very serious, for the commissioning personnel in normal work, the auxiliary exhaust pipe exhaust valve closed, remember.

  3、突然停電,循環泵停止,流速等于0。由于爐膛內耐火蓄熱體繼續放S熱是爐管中的導熱油超溫,而產生裂解、結焦,長期多積累也會使爐管炸壞,殃成大禍。因此要求樣按說明操作。

  3, sudden power failure, the circulatory pump stopped, the flow rate is equal to 0. Because the furnace refractory is heat regenerator continue to put S in the furnace tube heat conducting oil temperature, and pyrolysis and coking, long-term accumulation will make the furnace tube damaged, calamity into catastrophe. So ask for instructions.

  4、合理地選擇導熱油爐。按說明選擇導熱S油,且嚴謹超溫使用,千萬不能S圖省錢買不合格的油,更不能自己亂兌導熱油,否則幾個月多半年的時間,爐管堵塞,造成火災,后果不堪設想!

  4, reasonable selection of heat-conducting oil furnace. According to the choice of S thermal oil, and strict over temperature do not use S diagram to save money to buy substandard oil, but can not mess against the heat-conducting oil, or a few months up to six months time, jam, furnace tube caused by fire, the consequences be unbearable to contemplate!

  5、停爐,必須養按照說明操作規程執行,一般使導熱油溫度降到100度以下方可停止S熱油泵。

  5, stop the furnace must be kept in accordance with the instructions operating procedures, the general heat conduction oil temperature below 100 degrees, can stop the S hot oil pump.

  6、嚴謹隨意超溫操作,多加燃料,加大風量,使導熱油S處于超溫狀態,這樣導熱油裂解結焦即可發生,長久下去就會發生大的事故。

  6, rigorous, optional, ultra temperature operation, more fuel, increasing air volume, so that heat conduction oil S in the ultra warm state, so that heat transfer oil cracking coking can occur, long term will happen big accident.

同類文章:

文章標題:如何提高導熱油的使用壽命?

推薦閱讀/ Recommended reading

1、粘度和粘溫特性:粘度是液壓油的主要指標,對系統的平穩工作有著重要影響。粘度過小時,潤滑表面容易產生磨損,從而使液壓元件的內漏和外漏增加,泵容積效率降低,油溫上升...

壓縮機與油品常見故障診斷[2018-01-05]
詳述導熱油的成分與種類有哪些[2018-03-29]
避開四大誤區 正確添加汽車潤滑油[2017-10-23]
潤滑油廠家淺析潤滑油應如何鑒別[2018-06-29]
工業潤滑油的行業發展[2018-04-11]
導熱油廠家分享如何挑選優質導熱油?[2018-07-19]
導熱油應用行業及重要指標[2017-12-04]
潤滑油具有哪些作用特點![2018-09-20]
潤滑油在使用過程中為什么會出現變黑發[2017-08-21]
合成潤滑油最佳渦輪增壓車型小常識[2018-05-14]
  • 掃一掃,訪問手機站
七星彩预测专家推荐